User`s guide
REDUCING MONITORING LATENCY
66
MONITORING LIVE INPUT
There are two ways to monitor live audio input 
with a Traveler: 1) through the computer or 2) via 
CueMix™ DSP hardware monitoring. Figure 9-1 
on page 66 shows method 1, which allows you to 
add effects processing such as reverb and guitar 
amp effects via plug-ins in your audio software. See 
the next section, “Adjusting the audio I/O buffer” 
for details about how to reduce — and possibly 
eliminate — the audible monitoring delay that the 
computer introduces.
Figure 9-2 shows how to use CueMix™ DSP 
hardware-based monitoring, which lets you hear 
what you are recording with no monitoring delay 
and no computer-based effects processing. (You 
can add effects later, after you’ve recorded the live 
input as a disk track.) See “CueMix DSP hardware 
monitoring” later in this chapter for details on how 
to use CueMix DSP with your audio software, or 
with the included CueMix Console software.
If the material you are recording is suitable, there is 
a third way to monitor live input: use both methods 
(Figure 9-1 and Figure 9-2) at the same time. For 
example, you could route vocals to both the 
computer (for a bit of reverb) and mix that 
processed signal on the main outs with dry vocals 
from CueMix DSP.
1. Live input (from mic, guitar, etc.) 
enters the MOTU interface.
PC
2. Mic signal goes immedi-
ately to the computer (dry, 
with no effects processing).
3. Mic signal is 
‘patched thru’ back to 
the audio interface 
with reverb or other 
plug-in effects, if any.
Figure 9-1: There are two ways to monitor live audio inputs with a Traveler: 1) through the computer or 2) via CueMix™ DSP hardware
monitoring. This diagram shows method 1 (through the computer). When using this method, use your host software’s buffer setting to reduce
the slight delay you hear when monitoring the live input, but don’t lower it too much, or your computer might get sluggish.
4. Mic signal (with plug-in 
processing, if any) is routed 
to the main outs (or other 
outputs that you’ve specified 
in the software).
!Traveler Manual/Win Page 66 Monday, November 29, 2004 3:50 PM










