Owner's manual

Using the CD-RW with the USB interface

After the initial installation, you can connect or disconnect the CD-RW

drive without powering off your computer. To do these follow the steps

below.

Connect the CD-RW drive via the USB port

1. Connect the 36-pin connector to the interface connector of the CD-

RW drive.

2. Connect the AC adapter plug into the DC IN jack of CD-RW drive,

and attach the AC adapter to the AC power outlet.

3. Plug the port connector of the USB cable into the USB port of

computer. The CD-RW drive is now ready for use.

Disconnect the CD-R/CD-RW from computer

Remove the USB cable from the USB port on the computer.

Installing the application software

In order to write any data or audio tracks on a CD-R or CD-RW disk, you

will need to install recording software.

Insert the recording CD-ROM software into the CD drive. The program

will start and prompt you to select a program to use.

CD-ROM disk

There are two types of disks included with the CD-RW Station package.

CD-R This is a write-once disk. (Plain CD disk with out a label) Data

is permanently written on the disk. It is compatible with all CD-

ROM drives.

CD-RW A rewritable disk. (Has a CD-RW label on the CD) It is

compatible with CD-ROMs that support multi-read and have a

speed of 24x or higher.