User Manual

ManualsBrandsExpert Grill ManualsGrills & Outdoor Cooking3 Burner 27,000 BTU Gas Grill, Black, XG10-101-002-02

OWNER’S MANUAL

Important Safeguard

s ....................

Page 2

Limited Warranty ........................... 5

Expanded View & Hardware ................ 6 & 7

Assembly Instructions........................ 8

Installing LP Gas Tank....................... 12

Operating Instructions....................... 13

Cleaning and Care ......................... 14

Troubleshooting ........................... 16

The use and installation must conform with local codes or,

in the absence of local codes, with either the National Fuel

Gas Code, ANSI Z223.1/NFPA 54, Natural Gas and Propane

Installation Code, CSA B149.1, or Propane Storage and

Handling Code, B149.2, or the Standard for Recreational

Vehicles, ANSI A 119.2/NFPA 1192, and CSA Z240 RV

Series, Recreational Vehicle Code, as applicable.

This instruction booklet contains important safety

information. Please read and keep for future reference.

If you are assembling this unit for someone else, give

this manual to him or her to read and save for future

reference.

California Proposition 65: Handling the brass material on

this product exposes you to lead, a chemical known to the

State of California to cause cancer, and birth defects or

other reproductive harm. Wash your hands after handling

this product.

Outdoor LP Gas Barbecue Grill

Model No. XG10-101-002-02 / GBC2016W

& GBC2016WRS

WARNING

FOR YOUR SAFETY:

1. Do NOT store or use gasoline or

other ﬂammable liquids or vapors in

the vicinity of this or any other

appliance.

2. An LP cylinder not connected for

use shall not be stored in the vicinity

of this or any other appliance.

WARNING

FOR YOUR SAFETY:

For Outdoor Use Only! (outside any enclosure)

DANGER

If you smell gas -

1. Shut off gas to appliance.

2. Extinguish any open flame.

3. Open lid.

4. If odor continues, keep away from

the appliance, immediately call your

gas supplier or your fire department.

Failure to follow these instructions

could result in fire or explosion

which could cause property damage,

personal injury or death.

Manufactured in China for: RevoAce Inc. Limited

Hong Kong, China

1.800.694.0013 • service@revoace.com

9:00 am to 5:00 pm eastern time, Monday to Friday.

DANGER

Do not leave this appliance

unattended, especially cooking the

fatty meat and close the lid too long

time.

GBC2016W-OM-E-F107

Table of Contents

WARNING

CALIFONIA PROPOSITION 65

This product can expose you to

chemicals including benzene, which

is known to the State of California to

cause cancer. For more information,

go to www.P65Warnings.ca.gov.

Summary of content (17 pages)

PAGE 1
OWNER’S MANUAL Outdoor LP Gas Barbecue Grill Model No. XG10-101-002-02 / GBC2016W & GBC2016WRS Table of Contents Important Safeguards . . . . . . . . . . . . . . . . . . . . Page 2 Limited Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Expanded View & Hardware . . . . . . . . . . . . . . . . . 6 & 7 Assembly Instructions . . . . . . . . . . . . . . . . . . . . . . . . 8 Installing LP Gas Tank . . . .
PAGE 2
FOR YOUR SAFETY WW WARNINGS: 1. Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. 2. Read the installation, operation, and maintenance instructions thoroughly before installing or servicing this equipment. 3. Failure to follow these instructions could result in fire or explosion, which could cause property damage, personal injury, or death. 4.
PAGE 3
IMPORTANT SAFEGUARDS WW Never use an LP gas cylinder with a damaged body, valve, collar or footing. WW Dented or rusted LP gas cylinders may be hazardous and should be checked by your LP gas supplier prior to use. WW The LP gas cylinder should not be dropped or handled roughly. WW LP gas cylinders must be stored outdoors out of the reach of children and must not be stored in a building, garage or any other enclosed area. Your cylinder must never be stored where temperatures can reach over 125°F.
PAGE 4
IMPORTANT SAFEGUARDS WW It is essential to keep the grill’s valve compartment, burners and circulating air passages clean. WW Inspect grill before each use. WW Do NOT alter grill in any manner. Any alteration will void your warranty. WW Do NOT use the grill unless it is COMPLETELY assembled and all parts are securely fastened and tightened. WW Do NOT build this model of grill in any built-in or slide-in construction.
PAGE 5
IMPORTANT SAFEGUARDS WW Never cover entire cooking area with aluminum foil. WW Deaths, serious injury or damage to property may occur if the above is not followed exactly. Limited Warranty RevoAce Inc.
PAGE 6
Expanded View 1 8 3 9 7 2 11 5 12 4 14 6 10 15 13 18 10 16 19 19 17 21 20 23 22 24 29 27 25 26 28 29
PAGE 7
Parts List 1 Handle G2016-010 17 LP Gas Tank Retainer Wire G1716-100 2 Lid* G1716-010 18 Front Panel G2016-030 3 Brand Plate* B0109-LBD 19 Upper Cart Frame (2) G2016-050 4 Heat Plate (3) G1716-080 20 Upper Left Support Wire G2016-070 5 Top Hinge (2)* G1916-020 21 Cart Rear Support G2016-040 6 Bottom Hinge (2)* G1916-030 22 Lighting Hook* B0223-D00 7 Heat Shield G1916-050 23 Lower Left Support Plate G2016-080 8 Warming Rack G1716-060 24 Longer Leg (2) G2016-0
PAGE 8
1 Assembly Instructions Do Not Return To Place of Purchase Please have your owner’s manual and model number available for reference. Note: The model number is printed on a label which can be found on the inside door, back or side of the cart assembly. Assembly Tips: 1. Select an area where you will assemble this product. To protect components, choose a smooth surface that’s free of cracks or openings. 2. Spread out all parts. 3. Tighten all hardware as direct in each step.
PAGE 9
5 Attach Front Panel, Upper Left Support Wire and Lower Left Support Plate to Longer Legs Note: Leave hardware loose until grill body assembly in step 9. 6 9 Attach Shorter Leg to Front Panel Note: Leave hardware loose until grill body assembly in step 9. 18 20 18 23 B B B 7 B x2 Attach Rear Cart Support, Upper Left Support Wire and Lower Left Support Plate Note: Leave hardware loose until grill body assembly in step 9.
PAGE 10
9 10 Attach Grill Body Assembly Note: Match up with the grill body holes and upper cart frame holes. Install hardware and leave loose until 4 screws are attached then fully tighten. 10 1 F D 7 2 13 C E 11 Note: Fully tighten hardware. 1 11 C Attach Handle, Heat Shield and Control Knobs E x4 Insert Warming Rack Note: Attach the warming rack end per 4 sequence.
PAGE 11
13 11 Insert Grease Cup 14 Fully Tighten All Hardware
PAGE 12
Installing LP Gas Tank To operate, you will need one precision-filled standard grill LP gas tank with external valve threads. 17.9 in. / 45.5 cm 20 lb 9 Kg CAUTION WW LP gas tank must be properly disconnected and removed prior to moving this grill. 12.2 in. / 31 cm Inserting LP Gas Tank Securing LP Gas Tank Place precision-filled LP gas tank upright into the notches in the right cart frame so the tank valve is facing the gas line connection.
PAGE 13
Operating Instructions Figure 1 Checking for Leaks Burner Connections 1. Make sure the regulator hose and valve connections are securely fastened to the burner and the tank. 2. Visually check the connection between the burner/venturi tube and orifice. 3. Make sure the burner/venturi tube fits over the orifice. WW WARNING: Failure to inspect this connection or follow these instructions could cause a fire or an explosion which can cause death, serious bodily injury or damage to property.
PAGE 14
Operating Instructions (Continued) WW CAUTION: If burner flame goes out during operation, immediately turn the control knobs to the “ OFF” position,LP gas tank valve “CLOSED” and open lid to let the gas clear for 5 minutes before re-lighting. Turning Off 1. Turn LP gas tank valve to “CLOSED.” 2. Turn all control knobs clockwise to the “ OFF” position. Note: A “poof” sound is normal as the last of the LP gas is burned. 3. Disconnect LP gas tank per “Disconnecting LP Gas Tank” section.
PAGE 15
Cleaning Surfaces 1. 2. 3. 4. 15 Cleaning and Care (Continued) Wipe surfaces clean with mild dishwashing detergent or baking soda mixed with water. For stubborn surfaces, use a citrus-based degreaser and a nylon scrubbing brush. Rinse clean with water. Allow to air dry. Figure 6 Burner Flame Conditions Use this chart to see if your burners need to be cleaned. Cleaning Main Burners 1. Turn LP gas tank valve to “CLOSED.” 2. Turn all control knobs clockwise to the “ OFF” position.
PAGE 16
Troubleshooting Problem Possible Cause • LP gas tank valve is closed • LP gas tank is low or empty Burner will not light using igniter • LP gas leakage • Wires or electrode covered with cooking residue • • • • • Electrode and burners are wet Electrode cracked/broken - sparks at crack Wire loose or disconnected Wire is shorting (sparking) between ignitor and electrode Bad igniter • No gas flow • LP gas tank is low or empty Burner will not light with match • LP gas • Coupling nut and regulator not
PAGE 17
Troubleshooting • Grease buildup Flare-up Persistent grease fire Flashback (fire in burner tube(s)) Inside of lid is peeling (like paint peeling) • Excess fat in meat • Excessive cooking temperature • Grease trapped by food buildup around burner system • Remove and clean all grill parts per “Cleaning and Care” section • Trim fat from meat before grilling • Adjust to lower cooking temperature • Turn control knobs to “ OFF” • Turn LP gas tank valve to “CLOSED” • Leave lid in closed position and let fire b