Owner's manual

1.1.0 29/7/2009
•
The Voice Controller AU now has an effect variant so it will work in Digital Per-
former.
•
Added new OSC commands (registerOSCPathForParameter() and registerOSCPath-
ForParameterNormalized()) added, primarily for compatibility with TouchOSC.
•
Output configuration changed from a set of drop-down menus to a full matrix of
knobs.
•
Envelope scale parameters removed, since the same functionality is now offered by
the output matrix.
•
Added new 'velocity' output.
•
Added velocity-based scaling of envelopes.
•
Added Hz/V calibration mode.
•
Areas of the full MIDI note range note covered during calibration are now filled with
‘wrapped around’ values from octaves that are covered.
•
Added note priority modes (last/low/high) and retrigger modes (on/off).
•
Added ‘panic’ button.
•
Fixed some incorrect envelope triggering behaviours.
•
The ‘trigger’ output is now slightly longer than before (it was previously a single
audio sample).
NB v1.1.0 is not preset-compatible with earlier versions.
1.0.2 3/7/2009
•
The Voice Controller VST plug-ins are no longer virtual instruments, they are effects.
This allows Cubase to handle them properly.
1.0.1 30/6/2009
•
The Voice Controller AU now defines 3 stereo busses rather than 1 6 channel bus,
which allows Logic to handle it properly.
1.0.0 29/6/2009
•
First release.
!