Manual

1. To insert a honeycomb grid, align the grooves on the side of the grid with the

corresponding alignment ridges on the inside of the Grid Bezel. Firmly push the

honeycomb grid into the Bezel until it comes to a complete stop.

2. To remove a grid simply push it back out of the bezel.

The Rogue Grid was designed to produce 3 different grid angles; 25˚, 45˚, and

when aligned and stacked together, a 16˚ angle. The 25˚ and 45˚ angles are

marked on the outside curve of each honeycomb grid, describing the angle at

which light exits the grid. Smaller degree angles produce smaller spots of light.

For example, the 16˚ grid produces the smallest spot of light.

Attaching the Rogue Grid to your Flash:

1. Attach the grid strap to the ﬂash head by wrapping the bottom strap

around the ﬂash head. To ensure a secure ﬁt, pull the elastic band tight and

fasten the rubber tab to the velcro on the strap. The two snap positions on

the grid strap are designed to allow greater adjustability to accommodate

smaller and larger ﬂash heads.

Choosing a Grid Angle:

3. To create the 16˚ degree angle, align & stack both grids into the bezel

together. They may be stacked in any order.

inserting

attaching

grid alignment

bezel

grid

25˚16˚ 45˚

2. Position the grid strap on the ﬂash head so the top of the strap is even with

the face of the ﬂash. Once the honeycomb grid is attached, this positioning

will allow for about 1” between the face of the ﬂash and the grid.

3. Form a collar with the extended white ﬂaps of the grid strap and attach

the ends using the hook and loop.

4. Align “Rogue Grid” on the face of the grid bezel with the black “Rogue” label

on the top of the grid strap collar.

5. Firmly push the grid into the end of the collar. Be sure to check that the

edges of the collar tuck under the outer ring of the grid all the way around.

Warranty Information

Rogue Grid comes with a limited warranty to be free of defects in workmanship and

materials for a period of one (1) year from the date of original retail purchase. If the

product proves defective within the warranty period it will be replaced free of charge.

Please visit our website at www.expoimaging.com for more warranty information.

position

form collar

bezel alignment

tuck edges

More information can be found online at expoimaging.com