Installation Manual

18 19
OK
Mount Drain Saddle
at either location
Drain Saddle
The Drain Saddle is used to connect the Black Drain Line to the drain pipe under the sink. The Drain Saddle
is designed to t around a andard 1.5 inch OD (outer diameter) drain pipe. The Drain Saddle should
always be inalled above (before) the P-Trap and on a raight vertical or horizontal section of pipe.
To avoid clogging the drain line with debris do not inall the Drain Saddle after the drain pipe meets a
garbage disposal or dishwasher drain. Refer to the image below to see ideal Drain Saddle locations.
1. Once you have found where your Drain Saddle will go on the Drain Pipe make a mark for the opening
there with a marker or pencil.
2. Use your drill and an appropriate 1/4 inch (6.35mm) drill bit to drill a hole at your mark. Be careful to drill
through one side of the pipe and abilize your pipes while drilling to avoid damaging them.
3. Find the half of the Drain Clamp with a hole in its center. Then remove the backing from the Foam Gasket
(the foam circle at the center of the Gasket is disposable). Make sure to align the Foam Gasket hole with the
Drain Clamp hole and ick the adhesive side of the Gasket to the inner wall of the Drain Clamp half.
4. Take the half of the Drain Clamp without the Foam Gasket and insert a nut into the recess on each side.
5. Position both halves of the Drain Clamp on the drain pipe with the clamp’s opening aligned over the
drilled hole. The Foam Gasket will be between the drain clamp and the drilled hole. Push your 1/4 inch drill
bit through both holes (the Drain Clamp hole and the hole in the Drain Pipe) and remove to verify that the
clamp is properly aligned with the hole you drilled.
6. Secure the Drain Clamp halves together in place on the Drain Pipe. Screw the bolts through the Drain
Clamp half with the Foam Gasket and into the half you inalled the nuts into. (Do not over tighten. Make sure
there is equal space on both sides between the Drain Clamp halves.)
X
WARNING!
Never mount there!
OK
OK
X
X
P-Trap
Garbage
Disposal
Nut
Black Tube/Drain Line
Foam Gasket
Drain
Clamp
Drain Pipe
1/4” Hole
Bolt
Housing Assembly
Prepare Prelters
Leave the lters wrapped until you need them. When inalling
be careful not to touch the lter portion with your hands.
Remove the plaic wrap from the 3 Filter Housings and and
them upright. Make sure each Housing has two O-Rings rmly
in place at the top of the Housing and in the Housing’s lower
groove.
Top Part of the Unit
NOTE!
Reference image to place
each of the prelters in the
correct order:
- the orange Sediment Filter
will be on the far right (under
the label “TO FEED”).
- the blue Carbon Block Filter
will be on the opposite side,
the far left.
- the green GAC Filter will be
in the center, between the
other two. The white washer
will be facing up for correct
placement.
Filter
Housing O-Rings
Filter Housing
3rd 2nd 1
1. The RO Membrane is already on the syem. To
make sure the cap is secure, tighten the RO Membrane
Housing Cap clockwise by Wrench or hand.
2. Use your hands to screw each Filter Housing onto
the RO Syem. Finish tightening each housing using
the lter wrench. DO NOT OVERTIGHTEN!
Attention
1
2