Manualshelf

Installation Manual

ManualsBrandsExpress Water ManualsKitchen & Bath FixturesExpress Water Deionization Reverse Osmosis Filtration System – 6 Stage RO DI Water Filter with Faucet and Tank – Distilled Pure – Under Sink Home Softener – 100 GPD with Clear Housing & Pressure Gauge
891011121314151617
22 23
Syem Connections
You may have already completed some or all of these connections in previous eps. Make sure to remove
any plugs before inalling Tubing. Use the provided Lock Clips to secure any Tubing connections.
A to B Connect the RED Tubing to the Feed Water Adapter Valve (point A), then to the hole marked as “IN”
on the Leak Stop Valve (point B).
C to D Connect the WHITE Tubing to the hole marked as “OUT” on the Leak Stop Valve (point C), then to the
Sediment Filter Housing’s Male Elbow Fitting (point D).
E to F The RED Tubing is already connected to the Automatic Shut-O Valve (point E), connect the loose end
to the Carbon Block Filter Housing’s Male Elbow Fitting (point F).
G to H Connect the BLACK Tubing to the Flow Rerictor side indicated by the arrow on the Rerictor (point
G), then to the Drain Saddle (point H).
I to J Connect the YELLOW Tubing to the Inline Po Carbon Filter’s Stem Run Tee (point I), then to the Water
Storage Tank’s Tank Valve (point J).
K to L Connect the BLUE Tubing to the Stem Elbow at the end of the Inline Po Carbon Filter (point K), then
to your RO Faucet connection (point L).
A
BC
D
F
E
H
G
IK
L
J
Water Storage Tank
NOTE! Do not tamper with the air valve on the lower side of
the Water Storage Tank. It has been preset at 7-10 PSI.
1. Open the Water Storage Tank box and unscrew the Tank Stand
from the threaded em at the top of the Tank.
2. Wrap the threaded em 8-10 times with Teon Tape.
3. Screw the Tank Valve onto the threaded em. Make sure it is
tight, but do not over tighten.
4. Place the Water Storage Tank near the RO Syem in the de-
sired location. The Tank can and up raight or lie on its side.
5. Connect the Yellow Tubing to the Stem Run Tee of the Inline
Po Carbon Filter, then to the Tank Valve (See I to J on Page 23).
6. Keep the Tank Valve in the Closed Position until Syem Startup.
NOTE! If after 3-5 hours your tank does not ll: Connect the tank
directly to the cold water supply (bypassing the RO Syem) and
allow the tank to ll for about 1 minute. Then reconnect to your
syem as normal and empty the tank through faucet. This will
help activate the tank bladder.
NOTE! The Tank Valve only controls
water leaving the Water Storage Tank.
To op all incoming water use the
Feed Water Adapter Valve.
A. Tank Thread
B
A
C
B. Tank Valve
OPEN POSITION
C. Tank Stand
CLOSED POSITION