Installation Manual

READ THIS FIRST

Please pay attention to the following inallation and safety recommendations:

- Read the inallation manual before inalling this syem.

NOTE! Please make sure your inallation location has enough room for the RO Syem and Water Storage Tank

Incoming Water

Incoming water pressure mu be between 40 PSI and 80 PSI. If your water pressure is under 40 PSI you will

need a booer pump for your syem. If your water pressure is above 80 PSI you will need a pressure regula-

tor for your syem. Te your water pressure occasionally to make sure the syem is performing. If your water

is microbiologically unsafe or of unknown quality do not use this syem without adequate disinfection before

or after the syem. Extremely hot or cold incoming water will damage the syem and cannot be used.

Leaks

The Leak Stop Valve mu be inalled. Inspect all connections after the inallation to make sure no leaks

occur, wait until after the syem is pressurized (turned on) to inspect again. Check syem occasionally

after inallation or maintenance to make sure no leaks have developed. Inall the syem in a location with

adequate drainage.

General

This RO Syem unit is for climate controlled indoor use only. Exposure to overly high or low temperature

ranges will damage the unit. Follow all of your ate and local laws and codes regarding plumbing even if

they dier from what is ated in this manual. If your ate law requires it or you prefer to we recommend

using a professional licensed inaller or plumber who meets the requirements of this syem. All O-Rings,

ttings, lter caniers, and teon tape wear out after a certain period of time. The lifetime of your compo-

nents are subject to change with the quality of the water supplied. Do not handle an unwrapped lter direct-

ly with your bare hands as this can cause early lter failure. Use appropriate eye and face protection when

performing any drilling.

Maintenance

The owner/user is obligated to properly maintain the RO Syem when necessary, at lea every 1 year. This

includes the following:

- Replace the O-rings on the lter housings, membrane housing, ttings, and lter cartridges.

- Replace any connectors and lter housings with proper replacement parts.

- Sanitize your syem as often as needed (how often changes with the prole of your area’s incoming water).

- Always use proper replacement lter cartridges with the correct size and length replacements.

- Replace the Teon Tape on all threaded connections and ttings.

means, including photocopying, recording, or other electronic or mechanical methods, without the prior written

permission of the publisher, except in the case of brief quotations embodied in critical reviews and certain other

noncommercial uses permitted by copyright law.

Conditions