Installation Manual

ManualsBrandsExpress Water ManualsKitchen & Bath FixturesExpress Water Deionization Reverse Osmosis Filtration System – 6 Stage RO DI Water Filter with Faucet and Tank – Distilled Pure – Under Sink Home Softener – 100 GPD with Clear Housing & Pressure Gauge

12 13

Carbon

Filter

GAC

Filter

Sediment

Filter

Filter Housing

RO Unit

Top Part Components

Inline Po Carbon Filter - FLTIN01PKQ

Deionization Filter - FLTDI10J

RO Membrane Filter - FLTMEME50 / FLTMEME100

Bottom Part Components

Filter Housings - PRTHSF10DB14

Sediment Filter - FLTSED0501

GAC Filter - FLTGAC0501

Carbon Block Filter - FLTCAR0501C

Syem Components

RO Membrane

Deionization Filter

Inline Po Carbon Filter

1. Feed Water Adapter Valve

2. Leak Stop Valve

3. Sediment Filter

4. GAC Filter

5. Carbon Block Filter

6. Male Elbow 1/4”

7. Automatic Shut-O Valve

8. Male Elbow 1/8”

9. RO Membrane Housing

10. Check Valve

11. Drain Flow Restrictor

12. Drain Saddle

13. Stem Elbow

14. Deionization Filter

15. Stem Run Tee

16. Inline Post Carbon Filter

17. Tank Valve

18. Water Storage Tank

19. Tank Stand

20. QC Faucet Connector

21. Faucet

Tubing Quick Connect Guide

To Cut Tubing

Make your cuts again a at cutting surface with a razor blade, or use a handheld tube cutter. Any cuts to

your Tubing mu be perfectly raight.

NOTE!

Improperly cut Tubing may leak water or fail to lock into Fittings.

Wait until all elements of your RO Syem are in their nal locations before cutting your Tubing.

Make sure you measure the length you will need before cutting.

Attach Tubing

Push Tubing in raight and level with the

Collet. The Tubing will go 5/8ths of an inch

into the Collet before the lock is activated.

Pull out on the Tube to make sure the lock

has activated and the Tubing is secure.

NOTE! Once connected, make sure to

check tubing is secure.

5/8”

Insert or Remove Locking Clips

To lock a Tube in place make sure the

Tubing is fully inserted then slide the open

end of the Clip between the Collet and Fit-

ting. The Clip mu be removed before the

Tubing can be removed. To remove the Clip

pull away until it slides out from between

the Collet and Fitting.

Unlocked Locked

The tubing in your RO Syem uses a Quick Connect locking mechanism to

lock the Color Coded Tubing in place. Be careful not to damage your tubing

as you unpack it.

NOTE!

Make sure to remove any plugs before attempting to insert tubing.

Plug

Collet

Locking

Clip

Fitting

Release Tubing/Plugs

If there is a Locking Clip on the Collet it mu

be removed before the Tubing can be released.

Push and hold the Collet in to release the lock

while pulling out on the Tube/Plugs.

NOTE! Collet mu be held down while

pulling up on the tube to release the tube.

Hold

Down

Pull