Filter Change Instructions
Pre-Filter Change Soap Towel ACB Filter GAC Filter SED Filter Housing Wrench For more in depth instructions refer to your user manual 1. You will need a clean cloth, dish soap, and appropriate Sediment, GAC, and Carbon Block Filters. (We also recommend a bucket or bin large enough for the system to sit in. The system will release water when it is disassembled.) 2. Turn off the Cold Water Supply connected to the RO System, the Feed Water Adapter Valve, and the Tank Valve.
RO Membrane Change (Recommended change 1 year) 1. Open the RO Membrane Housing by unscrewing the cap. Pull out the RO Membrane with a pair of pliers. Be sure to note which side is the front and which side is the back of the membrane. 2. Wash out the RO Membrane Housing. Install the new RO Membrane in the Housing in the correct direction you noted earlier. Make sure to push the Membrane in firmly, then close the Housing by tightening the cap. PAC Change (Recommended change 1 year) 1.
UV Bulb DO NOT TOUCH THE BULB DIRECTLY, HANDLE WITH THE WHITE CERAMIC AREA DO NOT LOOK DIRECTLY AT THE UV BULB WITHOUT EYE PROTECTION UV Ballast 1. Unplug the power cord from the power outlet. DO NOT Unscrew the metal cap. 2. Carefully and slowly pull the black plastic cap off the UV Sterilizer (the bulb may come out with the cap, if it does not tilt the system until the white ceramic portion of the bulb is accessible). 3. Unplug the power cord from the UV Bulb and dispose of the old bulb. 4.
System Restart 1. Fully open the Feed Water Adapter Valve, Cold Water Supply, and the Tank Valve. 2. Open the RO Faucet handle and fully empty the tank before turning the Faucet handle off. 3. Let the system refill with water (this takes 2-4 hours). You can open the RO Faucet briefly to release any air trapped inside the system while it’s filling. (Be sure to check for new leaks during the first 24 hours after restarting) 4.
