Use and Care Manual

Filter Change
Instructions
Pre-Filter Change
For more in depth instructions refer to your user manual
1. You will need a clean cloth, dish soap, and appropriate Sediment, GAC,
and Carbon Block Filters. (We also recommend a bucket or bin large
enough for the system to sit in. The system will release water when it is
disassembled.)
2. Turn off the Cold Water Supply connected to the RO System, the Feed
Water Adapter Valve, and the Tank Valve. Then open the RO Faucet
handle to release pressure, close handle when the flow of water stops.
3. Place the RO System in the bucket and unscrew the 3 Pre Filter Hous-
ings using the Filter Housing Wrench. Remove old filters and dispose of
them.
4. Wash the Pre Filter Housings with dish soap then proceed to rinse until
all soap is removed.
5. Ensure that your hands are washed clean before unwrapping the new
filters. After unwrapping, place the new filters inside their correct hous-
ings. Make sure the O-Rings are in their proper locations.
6. Tighten the Pre Filter Housings using the Filter Housing Wrench. Do
not overtighten.
RO Membrane Change
(Recommended change 1 year)
1. Open the RO Membrane Housing by unscrewing the cap. Pull out
the RO Membrane with a pair of pliers. Be sure to note which side is
the front and which side is the back of the membrane.
2. Wash out the RO Membrane Housing. Install the new RO Mem-
brane in the Housing in the correct direction you noted earlier.
Make sure to push the Membrane in firmly, then close the Housing
by tightening the cap.
PAC Change
(Recommended change 1 year)
1. Now disconnect the Stem Elbow and Stem Tee from the sides of
the Inline Carbon Filter.
2. Note the orientation of the PAC old filter, install the new filter in
the same orientation. Remove the old filter from the holding clips and
discard. Next, insert the new filter into the holding clips and connect
the Stem Elbow and Stem Tee to the new Inline Carbon Filter.
Housing Wrench
SED
Filter
Towel
Soap
ACB
Filter
GAC
Filter