Use and Care Manual

System Restart
1. Fully open the Feed Water Adapter Valve, Cold Water Supply, and the Tank Valve.
2.
Open the RO Faucet handle and fully empty the tank before turning the Faucet handle off.
3. Let the system refill with water (this takes 2-4 hours). You can open the RO Faucet briefly to release
any air trapped inside the system while it’s filling. (Be sure to check for new leaks during the first 24
hours after restarting)
4.
After the Water Storage Tank has filled drain the entire system by opening the RO Faucet until the
water flow is reduced to a slow trickle. Then close the Faucet.
5.
Repeat steps 3 and 4 three times to fully flush the system (6-9 hours)
NOTE!
If the RO System is connected to a refrigerator do not drain the system through the
refrigerator water dispenser. The excess carbon fines from the new carbon filter will clog the internal
fridge filter.