Instructions / Assembly

2. Press the red pressure release button
Prepare for water discharge from system then press the red pressure
release button.
Use your Filter Housing Wrench to unscrew the housings from your
system.
Remove the old filter and throw it away. Drain any remaining water from
the housing
.
5. Align New Filter
Insert the new filter facing the correct direction. The carbon, KDF, or PHO filters will
need to have their o-ring facing the top of the system.
Make sure your filter is correctly aligned. Support the base of the housing and insert
it back into the top manifold. Then tighten the housing by hand.
Once the housing is hand tight, use your filter housing wrench to give a slight
additional turn. You should only need a fourth turn or a half turn with the wrench, be
careful not to over-tighten.
4. Reattaching Housing
Your o-ring may come loose during the housing removal. If it doesn’t
carefully remove it from the housing and apply your silicone lubricant
to the o-ring, before setting it back in place.
Apply lubricant to the threads of the filter housing
.
Note! Do not add bleach directly to any part of the system
3. Filter Cleaning
We recommend cleaning your filter housing once a year. To do this scrub
the inside of the housing and the inside of the top manifold with one
gallon of warm water mixed with 1 tablespoon of household bleach. Make
sure to protect your hands during cleaning. Rinse all parts with water until
all traces of bleach are gone.