Instructions / Assembly

7. Readying New Filters
Flush your new filters by turning on cold water from the closest faucet.
The water will become blackish as loose carbon particles are flushed out of the system. The water
may also appear cloudy as air bubbles are pushed out of the system and your pipes. This is perfectly
normal. Run the water until it becomes clear, then run for 5 additional minutes before turning the
faucet off.
Wait 30 minutes, then run the cold water again for 10 minutes.
Your system is now ready to use!
6. System Start-up
Once your filter has been replaced and your housing is in place you are
ready to turn on water supply to the system.
Check for leaks as the system fills with water.
If you discover a leak turn the water off, inspect your connection points
and o-rings, retighten and try again.