Installation Manual
22 23
Water Storage Tank
NOTE! Do not tamper with the air valve on the lower side of
the Water Storage Tank. It has been preset at 7-10 PSI.
1. Open the Water Storage Tank box and unscrew the Tank Stand
from the threaded em at the top of the Tank.
2. Wrap the threaded em 8-10 times with Teon Tape.
3. Screw the Tank Valve onto the threaded em. Make sure it is
tight, but do not over tighten.
4. Place the Water Storage Tank near the RO Syem in the de-
sired location. The Tank can and up raight or lie on its side.
5. Connect the Yellow Tubing to the Stem Run Tee of the Inline
Po Carbon Filter, then to the Tank Valve (See I to J on Page 23).
6. Keep the Tank Valve in the Closed Position until Syem Startup.
NOTE! If after 3-5 hours your tank does not ll: Connect the tank
directly to the cold water supply (bypassing the RO Syem) and
allow the tank to ll for about 1 minute. Then reconnect to your
syem as normal and empty the tank through faucet. This will
help activate the tank bladder.
NOTE! The Tank Valve only controls
water leaving the Water Storage Tank.
To op all incoming water use the
Feed Water Adapter Valve.
A. Tank Thread
B
A
C
B. Tank Valve
OPEN POSITION
C. Tank Stand
CLOSED POSITION
Syem Connections
You may have already completed some or all of these connections in previous eps. Make sure to remove
any plugs before inalling Tubing. Use the provided Lock Clips to secure any Tubing connections.
A to B Connect the RED Tubing to the Feed Water Adapter Valve (point A), then to the hole marked as “IN”
on the Leak Stop Valve (point B).
C to D Connect the WHITE Tubing to the hole marked as “OUT” on the Leak Stop Valve (point C), then to the
Sediment Filter Housing’s Male Elbow Fitting (point D).
E to F The RED Tubing is already connected to the Automatic Shut-O Valve (point E), connect the loose end
to the Carbon Block Filter Housing’s Male Elbow Fitting (point F).
G to H Connect the BLACK Tubing to the Flow Rerictor side indicated by the arrow on the Rerictor (point
G), then to the Drain Saddle (point H).
I to J Connect the YELLOW Tubing to the Inline Po Carbon Filter’s Stem Run Tee (point I), then to the Water
Storage Tank’s Tank Valve (point J).
K to L Connect the BLUE Tubing to the Stem Elbow at the end of the Inline Po Carbon Filter (point K), then
to your RO Faucet connection (point L).
A
BC
D
F
E
H
G
I
K
L
J