Manualshelf

Installation Manual

ManualsBrandsExpress Water ManualsKitchen & Bath FixturesExpress Water 5 Stage Home Drinking Reverse Osmosis Water Filtration System 50 GPD RO Membrane Filter - Modern Chrome Faucet - Ultra Safe Residential Under Sink Water Purification - One Year Warranty
891011121314151617
26 27
Rearting The Syem
1. Fully open the Feed Water Adapter Valve, Cold Water Supply, and the Tank Valve.
2. Open the RO Faucet handle and fully empty the tank before turning the Faucet handle o.
3. Let the syem rell with water (this takes 2-3 hours). You can open the RO Faucet briey to release any air
trapped inside the syem while it’s lling. (Be sure to check for new leaks during the r 24 hours after
rearting.)
4. After the Water Storage Tank has lled drain the entire syem by opening the RO Faucet until the water
ow is reduced to a slow trickle. Then close the Faucet.
5. Repeat eps 3 and 4 three times to fully ush the syem (6-9 hours)
NOTE! If the RO Syem is connected to a refrigerator do not drain the syem through the refrigerator
water dispenser. The excess carbon nes from the new carbon lter will clog the internal fridge lter.
How to Sanitize your RO Syem
(Recommended Once a Year)
1. Before you begin you will need a new Sediment Filter, GAC Filter, Carbon Block Filter, RO Membrane, Inline
Po Carbon Filter, and the Filter Housing Wrench. We also sugge using a bucket or bin large enough for the
syem to sit in (the syem will release a lot of water when it is disassembled).
2. Close any incoming water (Feed Water Adapter Valve).
3. Open the RO Faucet handle and drain the syem completely (wait until water ow ops completely), then
close the Faucet handle.
4. Use the Filter Housing Wrench to open the Filter Housings, then remove and dispose of ONLY the
following lter cartridges: Sediment Filter, GAC Filter, Carbon Block Filter, and RO Membrane
NOTE! Leave the Inline Po Carbon Filter in place! You will replace it after sanitizing the syem.
5. Mix 1 gallon of water with 2 tbsp of household bleach. Do not add bleach directly to the lter housing.
6. Fill up the Pre Filter Housings (Sediment, GAC, and Carbon Block Housings) with your mixed solution and
close the housings using your Filter Housing Wrench.
7. Open the incoming water to the syem (Feed Water Adapter Valve) and let it run for 10 minutes.
8. Open the RO Faucet handle and let it drain for 10 minutes.
9. Close the RO Faucet handle and wait for 10 minutes then open the Faucet handle again and wait for it to
drain completely. (If you smell bleach from your RO Faucet repeat eps 7-9)
10. You are now ready to replace all lters and reart your syem. Please refer to Syem Startup section for
detailed inructions, ignore any additional sanitation eps therein.
Troubleshooting
Note! Turn o the syem before servicing or inspecting
Vacation Mode
When you plan to not use your RO Syem for 2 weeks or more it should be Turned O. Locate the red
Feed Water Adapter Valve connected to your Cold Water Supply.
Turn O Syem: Turn the red Feed Water Adapter Valve to point away from the Red Tubing connection
(in the Closed position) to close the water supply to the syem.
Turn On Syem: Turn the red Feed Water Adapter Valve to point towards the Red Tubing connection
(in the Open position) to open the water supply to the syem.