Installation Guide
20
Elbow Fitting Inallation
Gauge Inallation
1. Screw a Male Elbow Fitting into the right-
mo Filter Housing (Sediment) marked “IN”.
Screw until tightened and the arm of the Elbow
is facing downward.
2. Secure the White Tubing into the Male Elbow
Fitting. Push hard enough on the tubing to
make sure the Quick Connect has locked
before moving on.
3. Screw the other Male Elbow Fitting (with red
plug) into the leftmo Filter Housing (Carbon
Block) marked “OUT”. Screw until tightened and
the arm of the Elbow is facing upwards at an 11
O’Clock angle (use the above image for reference).
4. Remove the Red Plug. Secure the Red
Tubing into the Male Elbow Fitting. Push hard
enough on the tubing to make sure the Quick
Connect has locked before moving on.
1. Put the end of the Pressure Gauge into one
of the top arms of the Stem Tee. Then, put the
Red Tubing into the opposite end as shown.
Both will go about 5/8ths inch into the tee to
secure.
2. Put the small bottom end of the Stem Tee into
the Male Elbow of the RO Membrane Cap. Use
Blue Locking Clips to secure all 3 connection
points as shown.
NOTE!
Not all RO Syems include a Pressure Gauge. If your syem does include a Gauge we will inall it now.