Installation Guide
21
Leak Stop Valve
Note! Please avoid contact of any liquid to the compressed textile. Failure to do so will activate
the textile and shut o the incoming water. Textile will not work if plaic wrap is not removed.
Please do not re-use Leak Stop pads once activated.
4. Take the plaic wrap o of the Compressed
Textile then place the Textile inside the Leak Stop
Valve as shown above. You may wish to insert
the Compressed Textile after Syem Startup is
complete in case of early monitored leaks.
INOUT
5. Turn the Stop Switch down and the
Leak Stop Valve is ready.
Red
Tube
White
Tube
INOUT
2. Position the Leak Stop Valve on the oor of the same
cabinet beside the syem. Any leaking water needs to
make contact with the valve. Use the two screws to secure
the Valve to the cabinet oor. Place the Leak Stop Valve in the
lowe possible location beside the RO Syem.
3. Connect one end of the Red Tubing into the Feed Water Adapter Valve and connect the other end
of the Red Tubing into the hole marked “IN” on the Leak Stop Valve. Then connect one end of the
White Tubing into the hole marked “OUT” on the Leak Stop Valve and connect the other end of the
White Tubing into the Male Elbow Fitting attached to the Sediment Filter Housing marked “IN”.
Red TubeWhite Tube
INOUT
1. Position the RO Syem in the
desired permanent location. Your
syem can be placed on its back
for space if needed.
Flow Closed Position
Flow Open
Position