Manualshelf

Installation Guide

ManualsBrandsExpress Water ManualsKitchen & Bath FixturesExpress Water Alkaline Reverse Osmosis Filtration System – 10 Stage RO Mineralizing Water Filter – Mineral, Antioxidant, pH + – Under Sink Purifier – 100 GPD with Pressure Gauge and Clear Housing
21222324252627282930
22
Water Storage Tank
NOTE! Do not tamper with the air valve on the lower side of
the Water Storage Tank. It has been preset at 7-10 PSI.
1. Open the Water Storage Tank box and unscrew the Tank Stand
from the threaded 󰍰em at the top of the Tank.
2. Wrap the threaded 󰍰em 8-10 times with Teon Tape.
3. Screw the Tank Valve onto the threaded 󰍰em. Make sure it is
tight, but do not over tighten.
4. Place the Water Storage Tank near the RO Sy󰍰em in the
desired location. The Tank can 󰍰and up 󰍰raight or lie on its side.
5. Connect the Yellow Tubing to the Stem Run Tee of the PAC
Filter, then to the Tank Valve (See I to J on Page 23).
6. Keep the Tank Valve in the Closed Position until Sy󰍰em Startup.
NOTE! If 3-5 hours after 󰍰artup your tank does not ll: Connect
the tank directly to the cold water supply (bypassing the RO
Sy󰍰em) and allow the tank to ll for about 1 minute. Then
reconnect to your sy󰍰em as normal and empty the tank through
faucet. This will help activate the tank bladder.
NOTE! The Tank Valve only controls
water leaving the Water Storage Tank.
To 󰍰op all incoming water use the
Feed Water Adapter Valve.
A. Tank Thread
B
A
C
B. Tank Valve
OPEN POSITION
C. Tank Stand
CLOSED POSITION