Manualshelf

Installation Guide

ManualsBrandsExpress Water ManualsKitchen & Bath FixturesExpress Water Alkaline Reverse Osmosis Filtration System – 10 Stage RO Mineralizing Water Filter – Mineral, Antioxidant, pH + – Under Sink Purifier – 100 GPD with Pressure Gauge and Clear Housing
21222324252627282930
25
Filter Change In󰎣ructions
This RO Sy󰍰em contains Filters that mu󰍰 be replaced at regular intervals to maintain proper performance.
Use only authentic Express Water lters.
How to Change the Sediment, GAC, and Carbon Block Filters (Prelters)
(Recommended about every 6 months)
1. You will need a clean cloth, dish soap, lter housing wrench
and appropriate Sediment, GAC, and Carbon Block Filters. We
also recommend a bucket or bin large enough for the syem to
sit in. The syem will release water when it is disassembled.
2. Turn o the Cold Water Supply connected to the RO Sy󰍰em
(refer to page 14), the Feed Water Adapter Valve (page 15), and
the Tank Valve (page 22). Then open the RO Faucet handle to
release pressure, close handle when the ow of water 󰍰ops.
3. Place the RO Sy󰍰em in the bucket and unscrew the 3 Prelter
Housings using the Filter Housing Wrench. Remove old lters and dispose of them.
4. Wash the Prelter Housings with dish soap then proceed to rinse until all soap is removed.
5. Ensure that your hands are clean before unwrapping the new lters. After unwrapping, place the new lters
inside their correct housings (refer to page 19). Make sure the O-Rings are in their proper locations.
6. Tighten the Prelter Housings using the Filter Housing Wrench. Do not overtighten. If these are the only
lters you are replacing continue to the Re󰍰arting the Sy󰍰em section on Page 26.
How to Change the RO Membrane
(Recommended about once a year)
NOTE! Make sure you have shut down the
RO Sy󰎣em (Step 2 in the above section).
1. Open the RO Membrane Housing by unscrewing the cap.
Pull out the RO Membrane with a pair of pliers. Be sure to note which side is the front and which side is the back.
2. Wash out the RO Membrane Housing. In󰍰all the new RO Membrane in the Housing in the correct direction
you noted earlier. Make sure to push the Membrane in rmly, then close the Housing by tightening the cap with
your hand. If this is the only/la󰍰 lter you are replacing continue to the Re󰍰arting the Sy󰍰em section on Page 26.
ACB SEDGAC
Make sure the O-Ring is in place before
you tighten the Membrane Housing Cap
How to Change the Inline Po󰎣 Carbon Filter
(Recommended about once a year)
NOTE! Make sure you have shut down the RO Sy󰎣em
(Step 2 in the Prelters section).
1. Fir󰍰 disconnect the Stem Elbow and Stem Tee from the sides of the Inline Po󰍰 Carbon Filter.
2. Note the orientation of the old lter and in󰍰all the new lter in the same orientation. Remove the old lter
from the holding clips and discard. Next, insert the new lter into the holding clips and connect the Stem
Elbow and Stem Tee to the new Inline Po󰍰 Carbon Filter (check page 12 for layout). If this is the only/la󰍰 lter
you are replacing continue to the Re󰍰arting the Sy󰍰em section on Page 26.