Installation Guide

6 7
Tools and Parts
Tools
Towels
Medium Crescent Wrench
Monkey Wrench
Pipe Cutter (Depends on pipes used) (eg: ratchet cutter,
hacksaw, wheel cutter)
Teon Tape
Plumber’s Silicone Grease
Depending on plumbing setup, you may need:
Soldering Iron or Torch
Power Drill
NOTE!
This is not a complete li of tools and parts, your home set up may require additional parts or
dierences from the inallation eps we detail. The eps we detail describe a typical inallation.
Parts
Depending on your setup you may need:
Shut-O Valves
Pipe Converter (1” to 3/4”) (or other)
Additional Piping
Pipe Hangers
Pressure Protection or Reducer Valve
Before You Begin
Make a li of all the plumbing parts and tools you will need to completely inall the syem to t your
home’s needs.
Conrm the inow direction of the syem and your inall location.
Turn o all incoming water to the house. The valve for this may be located under the house, on the
side of the house, under a ground panel, or elsewhere.
If you have an electric water heater turn o the electricity to your water heater.
If you have a gas water heater turn the knob to pilot.
We sugge planning for a bypass loop around the syem.
Use teon tape on the threaded connections