Installation Guide

8
How to Change the Direction
of Your Flow
Note: If needed for your setup these 󰍰eps will reverse the ow of your whole house sy󰍰em so your
feed water can enter the opposite side.
4. Rotate the black Housing Caps
180 degrees. The Housing Cap on
the right should now be the housing
cap on the left. Make sure the new
indicated by the cap is correct for
your setup.
5. Reattach the Housing Caps
to the sy󰍰em with the 12 screws,
then screw the pressure gauges
back in by hand. Make sure your
lters are in the correct order
before reattaching the Filter
Housings to the Housing Caps.
You have now reversed the
inow direction of your whole
house ltration sy󰎣em.
3. Unscrew the 12 screws on top
of the metal bracket to disconnect
the black Housing Caps from the
Metal Bracket. Leave the black
caps connected to each other and
make sure to note the direction
the Housing Caps are oriented in.
1. Unscrew the Filter Housings
for the Caps at the top
2. Unscrew the Pressure Gauge(s)
by hand and set them aside
Rotate 180 Degrees