USB 3.0 4-Port Hub User Manual Ver. 1.00 All brand names and trademarks are properties of their respective owners.
Contents: Chapter 1: Introduction ......................................................3 1.1 Product Introduction .................................................3 1.2 Features ......................................................................4 1.3 System Requirements ................................................4 1.4 Package Contents .......................................................4 1.5 Hardware Description ...............................................5 Chapter 2: Getting Started ........
Chapter 1: Introduction 1.1 Product Introduction Super-Speed USB 3.0 interface is the next revolution in I/O interconnect standards that will deliver the bandwidth and features required by PCs, consumer electronics and communications devices. With 10 times faster throughput than USB 2.0 standard and backward compatible with current USB device features, USB 3.0 interface will be the trendy of IT technology. Super-Speed USB 3.0 Hub data transfer rate up to 5 Gbps when connecting to USB 3.
1.2 Features Connects up to 4 USB devices Provide four USB 3.0 ports Compliant with USB 3.0 Specification 1.0 Supports simultaneous operation of multiple USB 3.0, USB 2.0 and USB 1.1 devices Up to 5Gbps data transfer rate Hot-swapping feature allows you to connect/disconnect devices without powering down the system No device drivers required for Hub installation LED to indicate Hub power 1.3 System Requirements Windows® XP/Vista/7 (32/64 bit) Available USB port (USB 3.
1 x User Manual 1 x Power Adapter (Optional) Note: Contents may vary depending on country/market. 1.5 Hardware Description Figure 1.
Power LED: The light will be on when the USB 3.0 4-Port Hub is powered up. Figure 2. Back Power Switch: If working current is insufficient, please stir this slide switch to ON, and plug the power adapter into the power jack of the USB 3.0 4-Port Hub.
Chapter 2: Getting Started 2.1 Hardware Installation 1. Plug the power adapter into the power jack of the USB 3.0 4-Port Hub. (If power adapter is available) 2. Plug the USB 3.0 4-Port Hub into your computer’s SuperSpeed USB 3.0 port. 3. Upon powering up your computer, the USB 3.0 4 Ports Hub will be recognized by the computer’s operating system. 4. Once complete, you are ready to plug all peripheral devices into your new USB 3.0 4-Port Hub. Note: Be sure to connect USB 3.0 4-Port Hub to USB 3.
If system can not install USB 3.0 4-Port Hub driver properly, be sure to confirm system’s USB 3.0 host controller’s driver working properly. We do suggest that you may re-install your USB 3.0 host controller driver again. Chapter 3: Troubleshooting Tips I can not run USB 3.0 SuperSpeed data transfer rate over this Hub. 1. USB 3.0 Hub must connects to USB 3.0 Port of your system. 2. Be sure to use true USB 3.0 device connection. Traditional USB 3.0 or USB 1.1 devices can NOT run USB 3.
How about connecting USB 3.0 Hub to traditional USB 2.0 Host Port? USB 3.0 Hub works, but only running under USB 2.0 High Speed mode. My USB 3.0 device does not work when connect to USB 3.0 Hub? Please confirm your settings as below one by one. 1. Affirm USB connection cable between USB device and Hub firmly. 2. Connect addition power adapter to your USB device, such as enclosure. 3. Make sure PC’s USB 3.0 Port works where USB 3.0 Hub connection.
