User manual

Jun/07 MN2000000098
11
4. Select the number of drives then press Enter.
5. Select Manual configuration then press Enter.
6. Select chunk size from 8k, 16k, 32k, 64 or 128k, then press
Enter.
7. Select the first drive, press Enter.
8. Select the second drive, press Enter.
9. Select the third drive, press Enter.
10. If applicable select the 4th drive pressing enter after each
selection.
11. Input the RAID size, press Enter.
12. When asked Are You Sure(Y/N)?, press Y to accept.
13. Press Ctrl+E to exit the BIOS.
14. When asked Are you sure to exit(Y/N)?, press Y to exit and
reboot.
15. Continue with FDISK and FORMAT steps as if you were
installing a conventional hard drive.
CONCATENATION
This RAID array allows you to use one, two, three or four hard drives
to a array. It does not provide any data protection or performance
improvement but can be useful for utilizing leftover space on disks.
1. As the BIOS boots press Ctrl+F4 or F4 when prompted to enter
the RAID BIOS.
2. At the next screen select Create RAID Set, then press Enter.
3. Select CONCATENATION, then press Enter.
4. Select the number of drives then press Enter.
5. Select the first drive, press Enter.
6. If applicable select the 2nd, 3rd, 4th drive pressing enter after
each selection.