User manual

Jun/07 MN2000000098

data, drive and partition information. The Low Level Format utility

works on single hard drive only, before the RAID set is configured.

Logical Drive Info

This menu item allows the display of the assignment of physical drives

within a logical set (RAID0, RAID1, etc.). This is display only

function.

BIOS Configuration

The SATA 150 4-Channel PCI RAID Card BIOS will appear every

time your system starts up. If the BIOS doesn’t show, please try your

controller in another PCI slot. During this (POST) process, the BIOS

will show up and indicate the devices attached to it.

Driver Installation

For Windows® 2000

For A New Installation

A new installation requires a floppy disk for the driver

installation. To make this floppy disk, copy the contents of

the “

PCI_IO\SiI 3114\Driver\RAID5” folder, found on the driver

CD, onto a blank floppy disk then follow the directions below.

1. Setup the RAID Array prior to Windows installation.

2. Follow Windows® 2000 installation procedure.

3. Restart the computer when prompted by the installation.

4. At the Windows® 2000 Setup screen, press F6 to install the RAID

driver.

5. When prompted, press S to specify the location of the driver.

6. Insert the floppy disk, then press Enter.