User manual

Jun/07 MN2000000098

7. Select Silicon Image SiI 3114 SoftRaid 5 Controller for

Windows 2000, then press Enter.

8. Press Enter again to finish driver installation, then follow the on-

screen instructions to complete the Windows installation.

For An Existing Installation

1. Setup the RAID Array prior to driver installation and boot up to

Windows.

2. At Found New Hardware Wizard, click Next.

3. Select Search for a suitable driver for my device (recommend)

then click Next.

4. Insert the driver CD, check CD-ROM drives, uncheck the other

boxes, click Next, then click Next again.

5. If the Digital Signature Not Found message appears, click Ye s.

Our driver has been thoroughly tested for stability and

compatibility.

6. Click Finish.

7. Repeat steps 2-6.

For Windows® XP/Server 2003

For A New Installation

A new installation requires a floppy disk for the driver

installation. To make this floppy disk, copy the contents of

the “

PCI_IO\SiI 3114\Driver\RAID5” folder, found on the driver

CD, onto a blank floppy disk then follow the directions below.

1. Setup the RAID Array prior to Windows installation.

2. Follow Microsoft’s Windows installation procedure.

3. Restart the computer when prompted by Windows’ installation.

4. At the Windows Setup screen, press F6 to install the RAID driver.

5. When prompted, press S to specify the location of the driver.