User manual

Jun/07 MN2000000098

4. At the Windows Setup screen, press F6 to install the RAID driver.

5. When prompted, press S to specify the location of the driver.

6. Insert the floppy disk, then press Enter.

7. Select Silicon Image SiI 3114 SoftRAID 5 Controller for

Windows XP/Server 2003, then press Enter.

8. Press Enter to finish driver installation, then follow the on-screen

instructions to complete the Windows installation.

Note: If the Security Alert warning pops up, click Ye s. Our driver has

passed Microsoft compatibility testing, this message appears during

new installation.

For An Existing Installation

1. Setup the RAID Array prior to driver installation and boot up to

Windows.

2. At the Found New Hardware Wizard:

XP(w/SP1 or earlier)/Server 2003: continue to step #3

XP(w/SP2 or later)/Server 2003(w/SP1 or later): select No, not

this time, then click Next.

3. Insert the driver CD, select Install the software automatically

(Recommended), and click Next.

4. Click Finish.

5. Repeat steps 2-4.

For Windows® Vista

For A New Installation

A new installation requires a floppy disk for the driver

installation. To make this floppy disk, copy the contents of

the “

PCI_IO\SiI 3114\Driver\RAID5” folder, found on the driver

CD, onto a blank floppy disk then follow the directions below.

1. Setup the RAID Array prior to Windows installation.