User manual

Jun/07 MN2000000098

7. Press Ctrl+E to exit the BIOS.

8. When asked Are you sure to exit(Y/N)?, press Y to exit and

reboot.

9. Continue with FDISK and FORMAT steps as if you were

installing a conventional hard drive.

For Existing Hard Drives with Data

1. As the BIOS boots press Ctrl+S or F4 when prompted to enter

the RAID BIOS.

2. At the next screen select Create RAID Set, then press Enter.

3. At the next screen select RAID1 then press Enter.

4. Select Manual configuration, then press Enter.

5. Select the Source drive, press Enter.

6. Select the Target drive, press Enter.

7. Select Create with data copy, then press Enter.

8. Select online copy, then press Enter.

Note: Selecting Online Copy builds the mirror while in Windows.

Selecting Offline Copy builds the mirror before exiting the RAID

BIOS.

9. Input the RAID size, press Enter.

10. Press Ctrl+E to exit the BIOS.

11. When asked Are you sure to exit(Y/N)?, press Y to exit and

reboot.

Note: If during boot the RAID BIOS reports an RAID1 set is in

Rebuild status, The rebuild will continue after boot sequence is

complete, disregard the message, continue booting, and let the Mirror

rebuild.