manual

2-Port SATA3 RAID/HyperDuo PCIe Card
2
The JP1 can be used to disable the BIOS on the card for some
critical applications, please leave the jumper at “ENA” all the time.
JP1: BIOS Enable/Disable Jumper
1. Power down the computer, remove the computer cover.
2. Choose an unused PCI Express bus slot, unscrew and remove the slot
cover.
3. Place the SATA3 RAID PCIe Card into the slot. Carefully press the
board into the slot until it seats firmly.
4. Secure the SATA3 RAID PCIe Card with the slot cover screw.
5. Install the SATA cables from the SATA connectors to your SATA devices.
6. Carefully reinstall the computer cover. Insert and tighten the
computer cover screws.
7. Power up the PC and observe the monitor. The BIOS lists all Serial ATA
devices attached to the SATA3 RAID/HyperDuo PCIe Card. For
example:
Marvell 88SE91xx Adapter – BIOS Version x.x.x.xxxx
PCIe x1 5.0Gbps
Mode: CPU AHCI
Virtual Disk
No Virtual Disk!
Physical Disk
[ID] [DISK Name] [Size] [Speed]
0 SATA ST32000641AS 1.83TB 6.0G
1 SATA ST32000641AS 1.83TB 6.0G
Press <Ctrl>+<M> to enter BIOS Setup or <Space> to continue
If the information displayed on your monitor is correct (the installed
devices are listed with the correct device name, etc.), congratulations!
You have successfully installed the SATA3 RAID/HyperDuo PCIe Card in
4. Hardware Installation
BIOS Enabled:
Jumper Installed at “ENA”
(Default)
BIOS Disabled:
Jumper Installed at “DIS”
3. Jumper Settings
ENA DIS
ENA DIS