User manual

USER MANUAL
9
Step 7. INSTALLATION OF MULTIPLE USB 3.0 DISPLAY ADAPTERS
Please plug the additional USB 3.0 DISPLAY ADAPTER into the available USB 3.0
port of your PC or Notebook.
The system will automatically start
the installation procedure and the
prompt message will pop-up on the
task bar.
The device driver software was
installed properly.
To make sure the USB 3.0 Display Adapters worked correctly, please reboot the
computer after finished the installation. After reboot the computer, the USB
extended display will be shown on the attached display device.
The device is now installed completely and ready to use.
If the extended display come out with the duplicate or blind screen, please right
click on the desktop of your system, it will pop up a screen and select “Screen
resolution” (a), or go to “START”→ “Control Panel”→ “Appearance and
Personalization”→ “Adjust screen resolution” (b). Then, select “Extend these
displays” (c) on the Display Property.