Owners manual

AVAILABLE MOUNTING PAD
OR SELECTED SURFACE
GENERAL INSTALLATION INSTRUCTIONS
Bed Rail/Auxiliary Lighting Kit
WARNING: BEFORE YOU START, READ THESE INSTRUCTIONS CAREFULLY.
 •Checktheowner’smanualofyourvehicleandlocaltrafcrulesregardingtherestrictionsontheuseoftheauxiliarylights.
 •Readthewirediagramrst.Ifyoucannotunderstandit,donotinstallthelightsyourself,havesomeonequaliedtodo
  theinstallationforyou.
 •Thelampsmaybecomehotwhileoperating;keepthemawayfromthetemperaturesensitivebodyparts.Donottouchor
  washthelightsforatleast10minutesafteruse.
Manufacturerassumesnoliabilityforanydamagecausedbyimproperuseand/orinstallationofits’product.
TOOLS NEEDED: Phillipsscrewdriver#2,Pliers,Wirecutter,Drillwith5/16”bit.
INSTALL THE LAMPS
 1.Selectthemountinglocationthatwillgiveyouamaximumlightrangeandwillnotcauseanyobstructionforyour
  vehicle’snormalfunction.
 2.Laythelamptoitsmountingposition,markdownthemountingpositiontothesurface.
 3.UsethesupplieddoublesidedtapetomounttheLEDinplace.
 4.Installthewiringharnessaccordingtothewiringdiagram.
 5.Withthesystemon,visuallycheckthelightpattern,andthenrmlytightenallscrews.
INSTALL THE WIRE/SWITCH
 1.Disconnectthenegative(-)terminalofthevehiclesbattery.(Thismayrequireresettingyourradio,clockorother
  electronicdeviceswhenreconnected.)
 2.Refertothewiringdiagram;layoutthewirethroughtheenginecompartmenttotheirproperlocations.Routethe
  twoblackwith+(positive)taggedwiresthroughtherewalltothedrivercompartment(Useanexistingopeningora
  smallholeshouldbedrilled.)
 3.Findaconvenientlocationnearthedashboardtomounttheswitch(usethevehiclesO.E.installationpadsifit’s
  available.)
 4.Followthewirediagram;connectallopenendwiresoftheharnesstotherelevantcomponentsorpositions.Makesure
  tosecuretheloosewiressothattheywillnotobstructthevehiclesnormalfunctions.
 5.Reconnectthenegativeterminaltothebatteryandturnontheswitchtotestthewholesystem.Ifthelightsdonotturn
  on,inspectthesysteminthefollowingseries:groundwire/batteryconnection/switch/lampconnection.Insteadof
  rewiringthewholesystem,alwaystrytolocatethetroublerst,thensolvetheproblembyxingthemistakeorreplace
  thedefectiveparts.
****** Before you drill, carefully locate a suitable area where there is no obstruction behind. ******
WIRING DIAGRAM
TONNEAU
LIGHTING
SYSTEM
TONNEAU
LIGHTING
SYSTEM
TONNEAU
LIGHTING
SYSTEM
TONNEAU
LIGHTING
SYSTEM