Owner manual

ManualsBrandsExtang ManualsCarPlatinum BlackMax: Ford F150 Flareside 92-96

PARTS INCLUDED IN YOUR KIT. You may want to lay them out in this manner for accessibility.

MISSING PARTS???

call Extang at

1-800-877-2588

Any and all needed parts will be shipped to you

directly. (DO NOT return whole kit to store)

Extang Corporation

5400 S. State Rd.

Ann Arbor MI 48108

734-677-0444, Fax: 734-677-8409

extang.com

I t e m N o . 0 0 11 - 1 4 0 3 R H P r i n t e d i n U . S . A .

INSTALLATION SHEET-Ford Fl are s id e ʻ 9 2– 96

Remove paper tape from all rails. Discard properly.

Foam has NO adhesive to

touch truck finish.

Wash truck bed.

P L E A S E

D O N O T

L I T T E R

Pull back on the ClickLock

release and remove one

corner from cab rail.

Feed tarp dowel into cab rail.

(NOTE: For easiest feeding action, place tarp on a flat

smooth surface, and keep dowel straight while feeding

into cab rail. Caution, pavement may scuff tarp.)

Reinsert corner piece into

cab rail until it “clicks” and

locks into place.

ClickLock

NOTE:

BLACKMAX has snaps on all rails.

IMPORTANT: Clean here with alcohol pad.

(Both Sides)

Spring Bows

Cab Rail

(BlackMax includes snaps on this rail)

Corner Pieces

For Classic Platinum only (This step does not apply to BlackMax)

Wall Plates

Alcohol

Pad

NEW Improved

“DOUBLE HOOK”

Side Rail Clamps

Tarp

Side Rails

Allen Wrench

Clamp Bolts

Tailgate

Off the truck bed,

connect the end rails to

the two side rails.

Summary of content (2 pages)

PAGE 1
IN S TA L LAT I O N S HEET- Fo rd Ca b Ra i l (B la ck F l a re s i d e ʻ 9 2 – 9 6 M ax inc lud es sn ap so Ta i n lg NEW Improved “DOUBLE HOOK” Side Rail Clamps at e th is ra i l) Corner Pieces Side Rails Tarp Spring Bows Clamp Bolts Allen Wrench MISSING PARTS??? call Extang at 1-800-877-2588 Wall Plates Any and all needed parts will be shipped to you directly. (DO NOT return whole kit to store) NOTE: BLACKMAX has snaps on all rails. PARTS INCLUDED IN YOUR KIT.
PAGE 2
5 When positioning wall plates be sure that they fit correctly against the truck bed wall. The plates must seat against the bottom of, and parallel to, the wall indentation. Place the rail assembly over the side of the truck box. Center rails evenly between cab and tailgate. (NOTE: Some applications have hard rubber risers (square rubber pad.) A riser must go toward tailgate. Some applications will have a riser at both ends, (most have no riser).