Installation Guide

DO600-en-GB_V7.4 12/16

AltitudeCompensation

1. WiththeunitON,momentarilypresstheCAL/RECALLbuttontwiceinquicksuccession

(‘SAL’isshowninthelowertemperaturedisplay.

2. PressandholdCAL/RECALLagainfor2secondstoentertheAltitudeMode(‘Ald’willbe

showninthelowertemperaturedisplay).

3. Thefactorydefaultvalueis

sealevel.EachpressoftheMODE/HOLDbuttonincreasesthe

compensationby1000ft.Themaximumvalueis20presses(20,000ftabovesealevel).

4. MomentarilypresstheCAL/RECALLbuttontosavethecompensationsettingandreturnto

thenormalmeasurementmode.

Auto‐PowerOFFFeature

Theautopowerofffeatureautomaticallyshutsthemeteroff10minutesafterthemostrecent

buttonpress.Todisablethisfeature,refertotheDisableAuto‐PowerOFFsection.

DisableAuto‐PowerOFFFeature

WiththeunitON,momentarilypresstheCAL/RECALLbutton,thenquicklypress andholdboth

theMODE/HOLDandON/OFFbuttonsuntil‘off’isdisplayed.TorestoretheAutoPowerOff

Feature(autopowerOFFenable)simplyturnthemeteroffandonagainusingtheON/OFF

button.

LowBatteryIndication

Whenthebatteryvoltagefallsbelowtheoperatingthreshold,‘BAT’willappearonthedisplay.

RefertotheMaintenancesectionforbatteryreplacementinformation.

StoringReadings

1. PresstheMODE/HOLDbuttontostoreareading.Thestoragelocationnumberwillbe

displayedonthelowerdisplay,whilethemaindisplayshowsthestoredreading.Themeter

willentertheHOLDmodeandthe“HOLD”indicatorwillappearontheLCD.

2. PresstheMODE/HOLDbuttonagaintoexittheHOLDmodeandreturntonormal

operation.ThenexttimeMODE/HOLDismomentarilypressedanotherreadingisstored

andsoon.

3. Ifmorethan25readingsarestored,previouslystoredreadings(startingwithreading

number1)areoverwritten.

RecallingStoredReadings

1. MomentarilypresstheCAL/RECALLbuttonandthenwithin4secondsmomentarilypress

theMODE/HOLD.Thelaststoreddatapointlocationwillbedisplayed(1to25).Eachtime

theMODE/HOLDbuttonismomentarilypressedthenextmostrecentlystoreddatapoint

willbedisplayed.

2. Afterthelast

datapointstoredisdisplayed,pressingtheMODE/HOLDbuttonagainreturns 

thedisplaytothebeginningofthelist.

3. PressingtheCAL/RECALLbuttonatanytimestopsthedataretrievalprocessandreturnsthe

metertothenormalmeasurementmode.

