User Manual

Operation

4.1 Powering the IRC130

The IRC130 is powered by a rechargeable lithium battery. Long press the

power button (centre) to switch the unit ON or OFF. If the unit does not power

ON, charge the battery by connecting to a 5V/1A rated AC wall charger (not

supplied) using the supplied USB-C cable. The USB-C jack is located in the

compartment at the top of the unit. Do not use the IRC130 while it is charging.

When the top flap is closed, the unit is rated IP54 for encapsulation. See Sec-

tion 7.2, Battery Considerations and Service for more information.

The IRC130 has an Auto Power OFF (APO) utility that switches it OFF auto-

matically if no buttons are pressed for the duration of the selected APO time.

Use the menu system (under Device Settings) To set the APO timer. See Sec-

tion 5, Programming Menu System, for more information.

4.2 IR Camera and Thermometer

Figure 4.1 Combined Thermal and Visible Image (MSX®)

1. Long press the power button to switch the unit ON.

2. If not already selected, choose the Thermal plus Visible Image mode in

the menu system (under Image Adjustments/Image Mode). You can adjust

the MSX® (Multi-Spectral Dynamic Imaging) alignment in the Image

Mode menu (press MENU at the MSX® image option and use the arrows

to make the adjustments; press MENU to confirm). Note that you can also

adjust the alignment directly in the normal operating mode using the arrow

buttons while viewing a Thermal Plus Visible image.

3. Point the camera toward the test area and scan as desired. View the cam-

era image on the IRC130 display.

#NAS100031; r. AD/63425/63425; en-US