User Manual

42280 V3.0 10/2007

Programming Mode P2; Datalogger Start Modes

1. Press the SET button to access the setup mode

2. Use the arrow buttons to select parameter P2

3. Press the SET button again

4. Select one of the four Start modes using the up/down arrow buttons (see list and

diagram below)

a. rEp (Repeat Start mode):

Logger starts once readings are

downloaded to PC

b. hEy (Keypad Start):

Datalogging begins after the

START/STOP button is held for

2 seconds

c. imm (Immediate Start):

Recording starts immediately

after exiting the setup mode

d. SCh (Scheduled Start):

Logging begins at a preset date

and time

5. Press the SET button to save the

setting

6. Use the arrow buttons to select another programming mode or press MODE to

exit the programming mode.