User Manual

42280 V3.0 10/2007
7
Programming Mode P3; Datalog Start Time
Note that parameter P3 will only be visible if the Start MODE is set to SHCEDULE
(Parameter P2 set to ‘SCh’).
1. Press the SET button to access the
setup mode
2. Use the arrow buttons to select
parameter P3
3. Press the SET button again
4. Use the up/down arrow buttons to set
the year
5. Press the SET button again
6. Use the up/down arrow buttons to set
month
7. Press the SET button again
8. Use the up/down arrow buttons to set
the day
9. Press the SET button again
10. Use up/down buttons to set the hours
11. Press the SET button again
12. Use up/down buttons to set the minutes
13. Press the SET button again
14. Use the up/down arrow buttons to set the seconds
15. Press the SET button again to store the settings
16. Press the MODE button to back out to the top level of this menu.
17. Use the arrow buttons to select another programming mode or press MODE to
exit the programming mode.
Y-M-D
Y-M-D
Y-M-D
H:M:S
H:M:S
H:M:S
8