User Manual

42280 V3.0 10/2007
8
Programming Mode P4; Datalogger Sample Rate
1. Press the SET button to access the
setup mode
2. Use the arrow buttons to select
parameter P4
3. Press the SET button again
4. Use the up/down arrow buttons to set
hours
5. Press the SET button again
6. Use the up/down arrow buttons to set
the minutes
7. Press the SET button again
8. Use the up/down arrow buttons to set the seconds
9. Press SET again to store the settings
10. Press the MODE button to back out to the top level of this menu.
11. Use the arrow buttons to select another programming mode or press MODE to
exit the programming mode.
Programming Mode P5; High and Low Alarms
1. Press the SET button to access
the setup mode
2. Use the arrow buttons to select
parameter P5
3. Press the SET button again
4. Use the up/down arrow buttons
to set the High Temperature
Alarm limit
5. Press the SET button again
6. Use the up/down arrow buttons
to set the Low Temperature
Alarm limit
7. Press the SET button again
8. Use the up/down arrow buttons to set the High Humidity Limit
9. Press the SET button again
10. Use the up/down arrow buttons to set the Low Humidity Limit
11. Press the SET button again to store the settings
12. Press the MODE button to back out to the top level of this menu.
13. Use the arrow buttons to select another programming mode or press MODE to
exit the programming mode.
Note: The AC Adaptor must be used for the audible alarm to sound