User manual

ROOM THERMOSTAT
22
Chapter 7
ROOM THERMOSTAT
DIGITAL THERMOSTAT AS PER STANDARD
The appliance can control the room temperature using a digital thermostat, which can lower the heating
power to minimum when a pre-set temperature is reached.
When the stove is started and has entered normal functioning mode, display D1 will show a number 1.
(e.g. 21°C); this value indicates the room temperature.
Use buttons 2 or 3 to enter the thermostat setting and the display will show a  ashing word that 2.
alternates at every impulse with “SET” and the temperature to be set; by pressing 2 the value decreases
and by pressing 3 it increases.
When the desired temperature has been adjusted let “3. SET” disappear from the display.
Adjust the desired heating power using buttons 4 and 5.4.
When the appliance reaches the temperature set it automatically goes to a minimum functioning mode
and the relative luminous indicator switches-o in display D1.
If digital thermostat functioning thermostat is to be excluded, use button 3, to take the temperature to
maximum until “MANUAL” appears in display D1.
The same functions can be obtained using the remote control.
MECHANICAL THERMOSTAT OPTIONAL
N.B: Installation must be performed by an authorised technician.
It is possible to thermostat a room adjacent to the room where the stove is positioned: just connect a
mechanical thermostat (boiler type) following the procedure described in the next point (it is recommended
to position the optional mechanical thermostat at a height of 1.50m from the ground).
MECHANICAL THERMOSTAT INSTALLATION OPTIONAL
N.B: Installation must be performed by an authorised technician.
Switch the appliance o using the master 1.
switch positioned on the rear of the stove2.
Remove the plug from the socket3.
Refer to the wiring diagram to connect the two thermostat cables onto the relative clamps 4.
positioned don the rear of the machine, one is red and the other black.
MECHANICAL THERMOSTAT FUNCTIONING
Set the desired heating power using buttons 4 and 5.1.
Using button 2 take the room temperature to minimum and “2. MINIMUM” will appear on the display.
Adjust the desired room temperature using the thermostat (e.g. 21 C°) and “  T ON” will appear on the
display.
When the stove reaches the desired temperature, it will go to minimum working conditions 3.
(“MINIMUM” will appear on D1). If the temperature lowers, the appliance will go back to “T ON” taking
back the previously left functioning setting.