User Manual

10
9. Repeat this process for the other stab half, the aileron control horns and the rudder control horns.
***PLEASE NOTE*** pull-pull rudder actuation with the rudder servo mounted in the rudder tray
under the canopy is recommended for lightweight 50cc engines in order to achieve proper balance. If
using a heavier 60cc or electric motor setup with large 12S LiPo batteries the rudder servo may be
mounted in the rear of the fuselage. This decision will determine whether you use a single control horn
set for push-pull rudder actuation or a dual horn setup for pull-pull. Be sure to use the included plywood
jig to make sure the rudder control horns are properly aligned while the epoxy sets.