User Manual

21
24. If using an electric motor we recommend mounting the ESC to the bottom of the motorbox either
with screws, nylon cable ties or Velcro straps.
25. If using a lightweight 50cc engine like the DA-50 mount your rudder servo in the servo tray under
the canopy using the manufacturer supplied mounting hardware. For proper geometry use the Extreme
Flight 3” pull-pull rudder arm with the cables crossed. Assemble the pull-pull cable linkage as shown by
inserting the end of the pull-pull cable into one of the aluminum crimp tubes. Insert the cable through
the hole in the brass fitting and back through the crimp tube. Loop the cable one more time through the
crimp tube and pull it tight. Use a crimping tool or set of side cutters to carefully crimp the tube in
multiple places, taking care not to cut through the crimp tube and cable. Repeat this for the other 3 cable
ends and install onto the servo arm and control horns using the provided 3mm hardware.