User Manual

26
31. There is a set of clear plastic baffles included to be used for electric setups to direct air over the
motor. Cut and trim the baffles and glue to the cowl inlets with Goop or medium CA.
32. Secure the cowl to the fuselage by inserting a 3mm bolt through the bottom of the cowl and into the
blind nut in the lower fuselage along with 2 3mm bolts inserted through the F1 former and into the blind
nuts in the cowl. Use blue thread lock on all 3 bolts! The factory has included an assortment of rubber
grommets that you can use to prevent your fuel line from getting chafed. You can see in this photo we
used a couple of them for the fuel tubing and the throttle servo lead. There are also 2 large grommets for
the hole on the side of the motor box where your ignition spark plug wire will exit.