User Manual

10. Use a 5/64" drill bit to enlarge the outermost hole in the nylon servo arm
that is provided with the servo. Use the longest arm included. Locate one of
the EZ connectors and insert the shaft of the connector into the 5/64" hole. A
drop of oil placed on the shaft of the connector will ensure that it moves freely
within the hole. Place the retaining nut on the threaded portion of the
connector shaft and screw down until tight, then back off the nut just enough
to allow the connector to turn freely. Place a single drop of CA on the end of
the threaded shaft to prevent the nut from coming off.
10

Modellbau Lindinger GmbH
Modellbau Lindinger GmbH Alte-Post-Str. 14 A-4591 Molln e-Mail: [e-mail] www.lindinger.at