User Manual

11. Two of the carbon pushrod/ball link assemblies are the same size. These
are the aileron pushrods. In addition locate 2 silver 2 mm screws, washers
and nuts from the hardware package. Secure the ball link side of the pushrod
to the aileron control horn on the side of the horn that will be closest to the
fuselage by inserting a 2mm bolt into a washer, then through the hole in the
brass ball and finally through the hole in the G10 control horn. Place a
washer onto the screw and secure with a 2mm nut. Be sure to use a drop of
blue Loctite to prevent the nut from backing off of the screw. Electronically
center your servo and attach the servo arm with the EZ connector that you
pre-fabricated in a previous step. Insert the carbon pushrod into the hole in
the EZ connector. This process is probably better explained in the following
series of pictures
.
11

Modellbau Lindinger GmbH
Modellbau Lindinger GmbH Alte-Post-Str. 14 A-4591 Molln e-Mail: [e-mail] www.lindinger.at