User Manual

13. Locate the fuselage, one piece carbon fiber landing gear, 2 silver 3mm
machine screws and 2 washers. Secure the landing gear to the fuselage by
inserting a 3mm screw into a washer, through the carbon fiber gear and into
the pre-installed blind nut in the fuselage. Make sure to use a drop of blue
Loctite on each screw to prevent them from backing out
.
14. Locate the 2 axles, 2 locking nuts, 2 wheels, 2 wheel collars and 2 wheel
pants from the hardware package. Place the wheel onto the axle and secure
with a wheel collar. Place the threaded portion of the axle through the hole in
the carbon gear and screw the lock nut onto the axle, but do not tighten
completely. There is a slot pre-cut in the wheel pant to allow it to fit over the
axle. Before installing the wheel pant place a drop of silicon based glue onto
the wheel pant just above the pre-cut slot. This will prevent the wheel pant
from rotating, but allow it to move in the case of a mishap which may help to
prevent damage. Slide the wheel pant into position over the axle and tighten
the nut on the axle, taking care to make sure the wheel pant is positioned
properly. Repeat this process for the remaining wheel pant. Again this is
probably better explained in the following series of pictures
.
14

Modellbau Lindinger GmbH
Modellbau Lindinger GmbH Alte-Post-Str. 14 A-4591 Molln e-Mail: [e-mail] www.lindinger.at