User Manual

15. Locate the horizontal stabilizer/elevator assembly and slide the elevator
off of the hinges. Insert the stabilizer into its slot and the carbon fiber wing
tube into the fiberglass sleeve. Use a ruler to insure that the stabilizer is
centered in its slot and compare the stabilizer to the wing tube to make sure it
is properly aligned. Sand or shim the slot if necessary. Secure the stabilizer
with CA.
16. Remove the covering over the left slot on the bottom of the elevator where
the elevator control horn will be installed. The elevator horn is the one with
the shortest shank that is glued into the surface. Scuff the portion of the
control horn that will insert into the elevator with sandpaper. Secure the
control horn with medium CA
.
16

Modellbau Lindinger GmbH
Modellbau Lindinger GmbH Alte-Post-Str. 14 A-4591 Molln e-Mail: [e-mail] www.lindinger.at