User Manual

21. Secure the tiller using the provided screw, but do not over tighten as the
tiller should be able to move on the screw as the ruder is deflected
.
22. Place the tailwheel wire in the proper position, aligned with the rudder
and lock into place with the 2 set screws.
23. Use the hardware provided with the servos to install the rudder and
elevator servos in their respective location in the rear of the aircraft. From
the pilot's perspective the rudder servo mounts on the left side of the fuselage
and the elevator servo mounts on the right side. The elevator servo should
have the output shaft toward the rear of the aircraft while the rudder servo
output shaft should be toward the front of the aircraft
.
20

Modellbau Lindinger GmbH
Modellbau Lindinger GmbH Alte-Post-Str. 14 A-4591 Molln e-Mail: [e-mail] www.lindinger.at