User Manual

4

Items needed for completion
-masking tape
-Thin and medium CA. We highly recommend Mercury M5T thin and M100XF medium
formulas as well as the Mercury glue tips.
-30 minute epoxy. I have used Pacer Z-Poxy for many years and it is a terrific product. It
cures in the allotted time and forms a permanent bond.
-Blue Loctite.
-Silicon based glue (Zap-A-Dap-A-Goo, etc.)
-Electric drill with an assortment of small drill bits.
-Small flat head and Phillips head screw drivers.
-Standard and needle nose pliers.
-Metric balldriver or allen key set.
-4 sub micro metal geared servos. All flight testing was performed with Hitec HS-65MG
and HS-5065MG digital servos and we strongly recommend the use of either of these high
quality servos.
-Torque 2818T/900 or 2814T/820 Brushless Outrunner motor.
-Airboss Elite 45 Amp ESC.
-4S 2100-2700 mah LiPo battery. Our favorite batteries in this aircraft have been the
FlightPower EON Lite 2550. We've also had great success with the Zippy Rhino bargain
LiPos available from www.hobbycity.com in both 2170 mah and 2350 mah sizes.
-APC 12x6 E prop (NOT the slow fly version!).
-52mm Extreme Flight spinner.
-2 18"-24" extensions for the 2 rear servos and 2 6"-8" extensions to go between the
receiver and the aileron servo leads. We recommend the 28 or 32 AWG extensions to save
weight.
-Adhesive backed Velcro and Velcro strap for battery retention.
Modellbau Lindinger GmbH
Modellbau Lindinger GmbH Alte-Post-Str. 14 A-4591 Molln e-Mail: [e-mail] www.lindinger.at