User Manual

3. Use a paper towel to wipe away most of the excess epoxy, leaving a small
fillet between the carbon pushrod and ball link. Position the pushrods
vertically while they cure as illustrated so the fillet remains in position. DO
NOT use CA for this bond!
4. Locate the 2 wing panels with ailerons as well as the 2 G10 aileron control
horns. Remove the ailerons from the wing and remove the covering over the
slot for the aileron horn on the bottom of the aileron with a sharp hobby
blade. Make sure you are doing this on the bottom of the aileron!
5. Scuff the portion of the control horn that will be glued into the aileron with
sandpaper.
6

Modellbau Lindinger GmbH
Modellbau Lindinger GmbH Alte-Post-Str. 14 A-4591 Molln e-Mail: [e-mail] www.lindinger.at