Reference Guide

Parameter Description
port The SNMP Trap receiver port. The default is port 162.
filter-name The filter name to associate with this host. Filters can be used to specify which traps are sent
to this host. The range is 1 to 30 characters.
no snmp-server host
This command removes the specified host entry.
Format no snmp-server host host-addr [traps|informs]
Mode Global Config
snmp-server user
This command creates an SNMPv3 user for access to the system.
Default No default users are created.
Format snmp-server user username groupname [remote engineid-string]
[ {auth-md5 password | auth-sha password | auth-md5-key md5-
key | auth-sha-key sha-key} [priv-des password | priv-des-key
des-key]
Mode Global Config
Parameter Description
username The username the SNMPv3 user will connect to the switch as. The range is 1 to 30 characters.
group-name The name of the group the user belongs to. The range is 1 to 30 characters.
engineid-
string
The engine-id of the remote management station that this user will be connecting from. The
range is 5 to 32 characters.
password The password the user will use for the authentication or encryption mechanism. The range is 1
to 32 characters.
md5-key A pregenerated MD5 (Message-Digest algorithm 5) authentication key. The length is 32
characters.
sha-key A pregenerated SHA authentication key. The length is 48 characters.
des-key A pregenerated DES encryption key. The length is 32 characters if MD5 is selected, 48
characters if SHA is selected.
no snmp-server user
This command removes the specified SNMPv3 user.
Format
no snmp-server user username
Mode Global Config
Management Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 101