Reference Guide

Parameter Description
retries Number of times to resend an Inform. The default is 3 attempts. The range is 0 to 255 retries.
auth Enables authentication but not encryption.
noauth No authentication or encryption. This is the default.
priv Enables authentication and encryption.
port The SNMP Trap receiver port. This value defaults to port 162.
filter-name The filter name to associate with this host. Filters can be used to specify which traps are sent
to this host. The range is 1 to 30 characters.
snmptrap source-interface
Use this command in Global Configuration mode to configure the global source-interface (Source IP
address) for all SNMP communication between the SNMP client and the server.
Format snmptrap source-interface {unit/slot/port | loopback
loopback-id|tunnel tunnel-id|vlan vlan-id}
Mode Global Configuration
Parameter Description
unit/slot/
port
The unit identifier assigned to the switch.
loopback-id Configures the loopback interface. The range of the loopback ID is 0 to 7.
tunnel-id Configures the IPv6 tunnel interface. The range of the tunnel ID is 0 to 7.
vlan-id Configures the VLAN interface to use as the source IP address. The range of the VLAN ID is 1
to 4093.
no snmptrap source-interface
Use this command in Global Configuration mode to remove the global source-interface (Source IP
selection) for all SNMP communication between the SNMP client and the server.
Format
no snmptrap source-interface
Mode Global Configuration
snmptrap ipaddr snmpversion
This command modifies the SNMP version of a trap. The maximum length of name is 16 case-sensitive
alphanumeric characters. The snmpversion options are snmpv1 or snmpv2.
Note
This command does not support a “no” form.
Management Commands
ExtremeSwitching 200 Series: Command Reference Guide for version 01 .02.04.0007 103